To ensure the normal operation of a winding machine, daily inspection and correct operation are indispensable important steps. First, an equipment manual should be established for daily recording and viewing of the operation and problems of the winding machine. Carefully check the workbench, cable guides and main sliding surfaces. If there are obstacles, tools, impurities, etc., it must be cleaned, wiped clean, oiled, and carefully check the equipment moving mechanism for new strains and bumps, such as The equipment should be notified to see if the analysis is caused by the fault, and make a record. Check the safety protection, power supply, limit and other devices should be complete, check the electrical distribution box should be closed firmly, the electrical grounding is good, check the equipment accessories Is it good? The over-wheels, felt clips, pay-offs, ceramic parts, etc. should be complete and properly installed, and the idling operation test runs to see if the operation is stable, with or without abnormal noise. Although the above work is cumbersome, it can effectively judge whether the device is in a good state and prevent the occurrence of a malfunction.

If there is no abnormality after inspection, then the equipment can be started normally for winding work. In the operation process, as the operator also needs to strictly follow the rules of use, there are many inadvertent operations that will damage the equipment to varying degrees. During use, Care should be taken not to do anything unrelated to work. When leaving the equipment, stop it, turn off the power supply, and the air source. It should be wound according to the process regulations. Do not arbitrarily increase the wire diameter, number of turns and winding speed. It is not allowed to use the winding machine with super specification, overload and overweight. The winding shaft and the mold should be correctly clamped. It is not allowed to use the long handle to increase the torque. The mold is fixed, the mechanical shift of the spindle and the cable mechanism, and the mold loading. Clips, adjustments, etc. should be carried out after parking. The protection device is provided to ensure the safety of the operator after the abnormal situation of the equipment. It is not allowed to dismantle the safety protection device on the equipment. The winding machine is especially equipped with a wire rod and It is not allowed to directly place tools, workpieces and other debris in the diameter of the winding, pay close attention to the operation. If abnormal phenomena such as malfunction, vibration, heat, crawling, noise, odor, and bruise are found, stop the vehicle immediately and check the fault. In order to continue working.

After the operation is completed, it should be properly stopped and cleaned. Firstly, the electrical and pneumatic switches are placed in the non-working position, the equipment is completely stopped, the power supply and air source are cut off, and the debris left in the equipment during the winding process is removed. Etc. Carefully refuel the cable displacement mechanism, the pay-off shaft, etc., and fill in the equipment manual carefully.